22 mm / 0.87 in Large Hole Cutter for Fabric & Leather PDV00220DEL

22 mm / 0.87 in Large-Diameter Hole Cutter

22 mm / 0.87 in large hole cutter prepares a repeatable circular opening in compatible workshop materials. The listed size is the actual cutting diameter. It is a cutting tool, not a hardware-setting die.

Select by the real opening required by the production step or hardware. A trade number, outer diameter or visual similarity is not enough to confirm the correct hole size.

Large-Diameter Cutting System

The tool follows the large cutting-family geometry with a cutting blade, guide/mapa and Polyemit support. Presses and hardware-setting dies are separate.

Typical Applications

• Fabric, leather and synthetic leather
• Canvas, tarpaulin and awning material
• Bag, belt and workshop accessory production
• Pre-punching before compatible hardware installation
• Sampling, prototypes and repeat production

Cutting vs. Setting

The cutter removes material; the setting die secures the hardware. After a 22 mm / 0.87 in opening is prepared, use the setting tool matched to the selected eyelet, rivet or other component.

Press Capacity and Working Height

Large cutters may need more controlled press force than small punches because a longer cutting edge contacts the material. Verify connection type, working height and press capacity before using manual, impact, electric or pneumatic equipment.

Material Thickness and Sample Cuts

Thin fabric, dense leather, multilayer canvas and coated tarpaulin can require different force. Thickness, stiffness, stretch and lower support affect edge quality. Test the real production material before repeat work.

Cut Quality and Tool Care

• Do not strike the cutting edge against bare metal.
• Keep the Polyemit support clean and level.
• Align the cutter squarely to the press table.
• Use controlled pressure on thick materials.
• Inspect the edge if incomplete cuts appear.

General Hole Cutting vs. Covered-Button Use

This listing is organized by actual hole diameter. The same physical cutter may also prepare fabric for a covered-button system when that relationship is verified; covered-button listings separately show ligne size and finished button diameter.

How to Select the Correct Size

If the application needs a 22 mm / 0.87 in opening, this is the matching cutter diameter. Hardware body shape, barrel height and washer structure remain separate considerations for the setting stage.

Before Ordering

• Required opening: 22 mm / 0.87 in
• Material thickness and layer count
• Press connection and working height
• Available press force
• Separate setting die when hardware is installed

Frequently Asked Questions

What diameter does this cutter produce?

The actual hole/cut diameter is 22 mm / 0.87 in.

Does it install hardware?

No. It prepares the opening only; setting hardware requires a separate die.

Which materials can it cut?

Compatible fabric, leather, canvas, tarpaulin, cardboard and technical textiles depending on thickness.

What should be checked before using a press?

Verify physical connection, working height and available press force.

Can the same cutter be used for covered-button fabric preparation?

Only when the physical cutter is verified for the relevant covered-button system.