11 mm / 0.43 in Precision Hole Cutter for Fabric & Leather PDV00110DEL

11 mm / 0.43 in Hole Cutter: Choose by Actual Diameter

11 mm / 0.43 in precision hole cutter is designed for repeatable circular hole preparation in compatible materials. It helps create the required opening before hardware installation and gives buyers a clear size reference based on real cut diameter. It is a cutting tool, not a setting die.

An oversized hole can leave unnecessary play around hardware, while an undersized hole can stretch or distort the material. Check the real post, tube, pin or inner-diameter requirement of the component before selecting the cutter.

Typical Applications

• Fabric and textile accessory production
• Leather and synthetic leather
• Canvas, bags, belts and workshop accessories
• Pre-punching before compatible hardware installation
• Sampling, repair and repeat production

Cutting and Setting Are Separate Operations

The cutter removes material to prepare the opening. A setting die forms or secures the hardware after the hole is ready. Do not assume that matching trade numbers guarantee compatibility; actual hardware dimensions remain the safer selection reference.

Tool Construction and Connection

This size follows the small punch family with a cutter and lower anvil. Existing M6 and 1/4 in connection options are retained; verify the physical thread before ordering.

Material Thickness and Test Cuts

Thin woven fabric, dense leather, multilayer canvas and coated materials react differently under pressure. Thickness, stiffness, stretch and layer count affect edge quality. Test the actual production material before repeat work.

Press Compatibility

Use with a compatible hand striking holder, manual press, impact press or suitable powered system when M6 or 1/4 in connection and working geometry match.

Cut Quality and Tool Care

• Do not strike the cutting edge against bare metal.
• Keep the lower support clean and level.
• Align the punch as squarely as possible to the material.
• Use controlled pressure on thick or multilayer materials.
• Inspect the edge if fraying or incomplete cuts appear.

Common Selection Mistakes

Choosing by hardware name alone can lead to the wrong opening. Start with the required finished hole diameter, then confirm material thickness and the hardware geometry that will pass through the material.

Who Uses This Tool?

Useful for textile and leather workshops, bag and accessory production, sample rooms, repair work and makers who need controlled circular openings. Standardizing the test-cut process can improve repeatability in small production runs.

Product-Family Guidance

Compare additional diameters and sets in the Hole Cutter Tools and Punching Dies category. Keep cutting tools separate from setting dies so each tool is selected by its real production task.

Before Ordering

• Required hole: 11 mm / 0.43 in
• Material thickness and stiffness
• M6 or 1/4 in connection
• Actual hardware dimensions
• Separate setting die when hardware will be installed

Frequently Asked Questions

What hole diameter does this tool create?

The actual cutting diameter is 11 mm / 0.43 in.

Is this a setting die?

No. It prepares the opening only; hardware installation requires a separate compatible setting die.

Which materials can it be used on?

It can be used on compatible thicknesses of leather, synthetic leather, fabric, canvas and compatible workshop materials.

How do I choose the connection?

Choose M6 or 1/4 in according to the physical connection on your press.

What does 11 mm mean?

It is the actual target hole diameter, approximately 0.43 in.